Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Viking D3 301 Series
Summary of Contents for Viking D3 301 Series
- Page 1 Installation Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Website at vikingrange.com 301 Series Built-In Dishwashers F20886A EN (092812)
-
Page 2: Table Of Contents
Table of Contents IMPORTANT – Please Read and Follow • Before beginning–please read these • Please ensure that this product is properly Warnings & Important Information _____________________________________________________3 instructions completely and carefully. grounded. Dimensions & Cutout Dimensions _____________________________________________________6 Specifications _______________________________________________________________________7 • DO NOT remove permanently affixed •... - Page 3 • Connect ground wire to green ground circuit. or moisture. connector in terminal box. • Viking Range Corporation will NOT • DO NOT use an extension cord. warranty any problems resulting from GFI • Failure to follow these instructions, can...
-
Page 4: Dimensions & Cutout Dimensions
Dimensions & Cutout Dimensions Specifications Built-In Dishwasher Description 301 Models - 7 / ( 6 0 8 ” ” Overall width 23-7/8” (60.6 cm) ( 6 1 ” Overall height from floor 33-7/8” (86.0 cm) min. to 35” (89.0 cm) max. ( 6 1 Overall depth from rear To edge of side –... -
Page 5: General Information
General Information Electrical Connections Grounding Instructions • Read these instructions carefully and • For service convenience, a shut-off valve 4. Care should be exercised, when the completely before installing the (not supplied) should be installed in the appliance is installed or removed to dishwasher. -
Page 6: Hardwire Conduit Option
Hardwire Conduit Option Hardwire Conduit Option (cont.) Green (Ground) Remove any loose items in the dishwasher and carefully Remove bottom pan. Note: Rapid removal of the bottom pan will Connect ground wire. Tighten screws on strain relief. Run wire through grommet on bottom pan. Note: Reinstall front plate. -
Page 7: Counter Balance Spring Adjustment
Counter Balance Spring Adjustment Installation (if necessary) Disconnect cable from hook. Remove spring from dishwasher. Carefully lay dishwasher on its back and attach the kick To adjust the depth of the kick plate, loosen screws on plate brackets. Screws for the brackets will already be the bracket and position in the required depth. -
Page 8: Leveling
Final Installation Leveling Equal distance 1.0” (2.5 cm) Cut here for 5/8” (1.6 cm) DOWN Cut here for 3/4” (1.9 cm) To check level, front to back, pull the top rack half-way out of (Discharge with food waste disposer) Place a level on handle, then adjust to appropriate Identify discharge connection size;... -
Page 9: Performance Checklist
Final Installation (cont.) Performance Checklist Testing for Leaks Unit Reset A qualified installer should carry out the following • If the unit should need to be reset for any checks: reason, push and hold the “START” button for 4 seconds. Remove packaging and parts. -
Page 10: Service & Registration
All servicing should be referred to a qualified technician. Contact Viking Range Corporation, 1-888-VIKING1 (845-4641), for the nearest service parts distributor in your area or write to:...