Check List - Samsung SyncMaster 920NW User Manual

Check List

Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call
Information section or contact your
Symptom
No images on the
screen. I cannot turn
on the monitor.
dealer.
Check List
Is the power cord connected
properly?
Can you see "Check Signal Cable"
on the screen?
If the power is on, reboot the
computer to see the initial screen
(the login screen), which can be
seen.
Can you see "Not Optimum
Mode","Recommended Mode
1440 X 900 60 Hz" on the screen?
There is no image on the screen.
Is the power indicator on the monitor
blinking at 1 second intervals?
the phone number on the
Solutions
Check the power cord connection
and supply.
(Connected using the D-sub
cable)
Check the signal cable connection.
If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows ME/XP/2000) and then
change the frequency of the video
card.
(Refer to the Preset Timing
Note: If the initial screen (the login
screen) does not appear,
the Service Center or your
You can see this message when the
signal from the video card exceeds
the maximum resolution and
frequency that the monitor can
handle properly.
Adjust the maximum resolution and
frequency that the monitor can
handle properly.
The monitor is in PowerSaver mode.
Press a key on the keyboard to
activate the monitor and restore the
image on the screen.
If there is still no image, press the
' ' button.
Then press any key on the keyboard
Modes)
contact
dealer.