Samsung SyncMaster 760TFT Manual page 47

Check List
Q & A
Self-Test Feature
Check
No images on the
screen. I cannot
turn on the monitor.
I cannot see the On
Screen Display.
Before calling for service, check the information in this section to see if you can remedy any
problems yourself. If you do need assistance, please call the phone number on the
warranty card, the phone number on the Information section or contact your
Symptom
Is the power cord connected
properly?
Can you see "No Connection,
Check Signal Cable" on the
screen?
If the power is on, reboot the
computer to see the initial
screen(the login screen), which
can be seen.
Can you see "Video mode not
supported" on the screen?
There is no image on the
screen. Is the power indicator
on the monitor blinking at 1
second intervals?
Have you locked the On
Screen Display (OSD) Menu to
prevent changes?
Check List
dealer.
Solutions
Check the power cord connection
and supply.
Check the signal cable connection.
If the initial screen (the login screen)
appears, boot the computer in the
applicable mode (the safe mode for
Windows 95/98/ME/XP/2000 and
then change the frequency of the
video card.
(Refer to the Preset Display
Note: If the initial screen (the login
screen) does not appear,
service center or your dealer.
You can see this message when the
signal from the video card exceeds
the maximum resolution and
frequency that the monitor can
properly handle.
Adjust the maximum resolution and
frequency that the monitor can
properly handle.
The monitor is in PowerSaver mode.
Press a key on the keyboard or
move the mouse to activate the
monitor and restore the image on the
screen.
Unlock the OSD by pressing the
MENU button for at least 5 seconds.
Modes)
contact a