Summary of Contents for W Box Technologies 600 LB HOLDING FORCE
Page 2
Magnetic Lock Wiring Instructions A terminal block is provided for wiring the maglock to the power supply. Set jumpers properly for 12VDC or 24VDC operation. (Cover all 4 pins = 12V - Cover 2,3 middle pins = 24V) Connect the ground lead from a DC power source to the (-) terminal. Connect the positive lead from a DC power source to the (+) terminal.
Page 3
Armature Plate Hardware Installation Diagram Armature plate must be mounted to door using the rubber washer sandwiched between the metal washers provided. Do not excessively tighten bolt. Armature must float on door. Screw locking agent should be used on each screw. Care and Maintenance Magnetic locks have no internal moving parts and require a minimum amount of maintenance.