Parts Description - Makita XCV08 Instruction Manual

PARTS DESCRIPTION

► 1. Tank cover 2. Powder filter (HEPA) 3. Damper
4. Prefilter 5. Tank
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Always wear dust mask during
assembly or maintenance.
Installing the powder filter (HEPA)
and prefilter (for dry dust)
CAUTION:
Never pick up water or other liq-
uids or wet dusts when using the powder filter.
Picking up such things may cause the powder filter
breakage.
To use powder filter:
1. Place the prefilter in the tank with aligning the
mounting position markings.
2. Mount the damper on the powder filter and then
place them in the prefilter with aligning the mounting
position markings.
3.
Finally, mount the tank cover and lock it.
1
2
3
4
5
► 1. Tank cover 2. Powder filter (HEPA) 3. Damper
NOTICE:
sure that prefilter and damper are always used
together. It is not allowed to install powder filter
solely.
Installing the paper pack
Optional accessory
use the prefilter together that is preinstalled on
the tool. Failure to use the prefilter together may
cause unusual noise and heat, resulting in a fire.
sure that powder filter, damper and prefilter are
always used together.
1.
► 1. Rubber holder
14 ENGLISH
6
6
6
4. Prefilter 5. Tank 6. Mounting position marking
Before using the powder filter, make
WARNING:
When using the paper pack, also
CAUTION:
Before using the paper pack, make
Remove the rubber holder.
1
1
2
3
4
5