Playing Back - Onkyo TX-RZ830 Instruction Manual

Playing Back

Contents Connections
≫
Set the remote controller to the ZONE control mode (ZONE 2/ZONE 3)
( p99, 100), and then perform the following operations.
1. Point the remote controller at the unit, and press .
• "Z2" or "Z3" on the display of the main unit lights up.
• ZONE 3 cannot be turned ON unless "2. Speaker" - "Configuration" - "Zone
Speaker" in the Setup menu (
2. Press the input selector of the input source you want to play in the separate
room. To control on the main unit, press ZONE 2 button or ZONE 3 button, and
then within 8 seconds, press the input selector button of the input to be played
in the separate room. To play the same source in the main room and separate
room, press ZONE 2 button or ZONE 3 button of the main unit twice.
3. If the unit is connected to the pre-main amplifier in the separate room, adjust
the volume on the pre-main amplifier. If the unit is connected to the power
amplifier or ZONE speaker in the separate room, adjust the volume on the
remote controller. To do this on the main unit, press ZONE 2 button or ZONE
3 button, and then within 8 seconds, adjust the volume using the MASTER
VOLUME dial.
• When adjusting the volume of the power amplifier placed in the separate
room by using this unit, set "6. Multi Zone" - "Zone 2" (or "Zone 3") - "Output
Level" ( p146) to "Variable" on the Setup menu.
• The sound quality of the power amplifier connected in the separate room
can also be adjusted. Press the ZONE 2 button of this unit, and then press
the TONE button within 8 seconds. Then turn the TONE dial for adjustment.
• Information of a connected device can be displayed on the TV in the
separate room. Set the remote controller to the ZONE control mode (ZONE
2), and then press
• If you turn the unit to standby during multi-zone playback, the Z2 or Z3
indicator is dimmed, and the playback mode is switched to playback in a
separate room only. Setting ZONE 2/ZONE 3 to on while the unit is in standby
also switches the playback mode to playback in a separate room only.
• For ZONE 2 output, audio from externally connected AV components can
101
Front Panel≫ Rear Panel≫ Remote≫
Playback
≫
p132) is not set to "Zone 2/Zone 3".
.
Setup
≫ ≫