Advertisement
System Requirements
Before you install the CD-ROM drive, we strongly recommend that you make certain
that your set-up meets the system requirements listed below.
Item
Type of computer
Free expansion unit
Disk space
MS-DOS version
Windows version
Installing the CD-ROM Drive
Install the CD-ROM drive in your computer horizontally, making sure that the Open/Close
button is on the right.
To install the drive, proceed as follows.
1
Turn OFF your computer. Remember to verify the
configuration jumper on the rear of the CD-ROM drive.
2
Remove the cover of your PC. (main unit of the computer)
3
Remove the blank cover panel of the 5.25 inch unit in
which the CD-ROM drive is to be installed.
4
Connect the CD-ROM drive to the IDE interface and power
cables Iocated inside your computer.
Connectors are keyed so it is impossible to put them in
an incorrect position. Do not force the connectors, if they
do not seem to fit.
5
Install the CD-ROM drive into the unit and secure it with
mounting screws. (recommended standard M3x6x4)
Depending on your PC model, you may need to
attach guide rails to the drive, so that the drive is
held firmly in place.
If you use screws that are longer than the
recommended standard, you may damage the
drive.
6
Put the cover back on your PC.
Description
IBM 486SX 20MHz (or higher) with
an IDE interface(or a 100% IBM-
compatible computer)
5.25 inch
100KB minimum
5.0(or higher)
3.1(or higher)
4
Installing the Software
You can install the device driver for DOS or for Windows.
¡ Do not install DOS Driver when the program of Windows 95/98 is going on.
(Remark CD-ROM Driver in the state of CONFIG. SYS.)
1
Turn on your computer and wait for it to boot.
2
Insert the driver disk into a floppy disk drive(usually the A drive).
If you are a...
3
Then :
Type a: at the DOS prompt
DOS user
Press the RETURN key
Windows user
Access the File Manager
Click on the A icon.
Windows 95/98 user
When you are in Windows 95/98, it is not
necessary to install Device Driver.
Whereas, when you are in Dos Mode of
Windows 95/98, then install as follows.
Click on MY COMPUTER icon.
Click on the A icon.
Run the CDSETUP program:
4
Then :
If you are a...
DOS user
Type CDSETUP after the
Press RETURN
Windows user
Double-click CDSETUP.EXE from the Windows
File Manager
5
To...
Confirm the installation
Exit without installing
Result :
If you answer Y(Yes), the installation program automatically
Creates a SAMSUNG directory on your hard disk
Copies the required softwares (mscdex.exe and sscdrom.sys)
Modifies the CONFIG.SYS and AUTOEXEC.BAT files
6
When the Setup Completed screen is displayed, remove the installation
floppy disk from the drive.
7
Reboot your system.
Result :
The computer restarts
Both the device driver and MSCDEX are loaded
A:
prompt
Then enter...
Y
N
5
Advertisement
