Pioneer RG52F3JBGEFU1 Owner's Manual page 4

0 SELF CLEAN Button
Active/Disable Self Clean function.
Airborne bacteria can grow in the moisture
that condenses around heat exchangers in
the unit. With regular use, most of this moisture
is evaporated from the unit. By pressing the
SELF CLEAN button, your unit will clean itself
automatically. The cleaning cycle takes 30
minutes, after which the unit will turn off a
CD
automatically. Pressing the SELF CLEAN
@
button mid-cycle will cancel the operation
and turn off the unit.
@
You can use SELF CLEAN as often as you like.
NOTE: You can only activate this function in
COOL or DRY mode.
0
(:)
0 FP Button
• Active/Disable freeze protection function.
Push this button during the heating operation
(only when the setting mode is HEAT), the
freeze protection function is activated. The unit
will operate at high fan speed with the
temperature automatically set to 46
display window of indoor unit will display• FP'.
For the unit without display area, the Defrost
indicator light will be keeping on for 2 seconds,
LED Button
Disable/Active indoor screen Display. When
pushing the button, the indoor screen display
is cleared, press it again to light the display.
UP Button(...c,.)
Push this button to increase the indoor
°
temperature setting in 1 F increments to 86
DOWN Button( ""'7 )
Push this button to decrease the indoor
°
temperature setting in 1 F increments to 62
NOTE: Press and hold•' ...c,. • and'' ""'7 "
buttons together for 3 seconds will alternate
the temperature display between the
scale.
°
F.The
O
-
＠
＠
＠
°
F.
°
F.
° °
C & F
and then be off for 2 seconds by turns.
Press ON/OFF,SLEEP, FP, MODE, FAN
SPEED.UP, DOWN buttonwhile operating
will cancel the freeze protection function.
@ TIMER ON Button
Press this button to initiate the auto-on time
sequence. Each press will increase the auto­
timed setting in 30 minutes increments. When
the setting time displays 10, each press will
increase the auto-timed setting 60 minutes
increments. To cancel the auto-timed program,
simply adjust the auto-on time to 0.0.
6> TIMER OFF Button
Press this button to initiate the auto-off time
sequence. Each press will increase the auto­
timed setting in 30 minutes increments. When
the setting time displays 10, each press will
increase the auto-timed setting 60 minutes
increments. To cancel the auto-timed program,
simply adjust the auto-off time to 0.0
@ DIRECT Button
Used to change the louver movement and set
the desired up/down air flow direction. The
°
louver changes 6 in angle for each press.
©SWING Button
Used to stop or start horizontal louver auto
swing feature.
�FOLLOW ME Button:
Push this button to initiate the Follow Me
feature, the remote display is actual tempera­
ture at its location. The remote control will
send this signal to the air conditioner every 3
minutes interval until press the Follow Me
button again. The air conditioner will cancel
the Follow Me feature automatically if it does
not receive the signal during any 7 minute
interval.
＠
－
—
『