Activity Cards; Battery Information; Battery Care And Maintenance Tips - Learning Resources Code & Go Robot Mouse Activity Manual

Activity Cards

This set also includes 10 double-sided Activity Cards featuring 20 mazes. These cards can be used as
an educational tool to help young programmers "ramp up" their skills. Start out with card 1 to teach
the very basics, and follow in number sequence as logic and critical thinking skills improve.
For all the mazes on the activity cards, the goal is to program your robot mouse to reach the cheese.
Each of these mazes should be completed in the fewest steps possible. For mazes with tunnels, be
sure to have Colby pass under each tunnel before reaching the cheese.

Battery Information

Installing or Replacing Batteries
WARNING! To avoid battery leakage, please follow these instructions carefully.
Failure to follow these instructions can result in battery acid leakage that may cause burns, personal
injury, and property damage.
Requires: 3 x 1.5V AAA batteries and a Phillips screwdriver
• Batteries should be installed or replaced by an adult.
• The Robot Mouse requires (3) three AAA batteries.
• The battery compartment is located on the bottom of the unit.
• To install battery, fi rst undo the screw with a Phillips screwdriver and remove
the battery-compartment door. Install batteries as indicated inside the compartment.
• Replace compartment door and secure with screw.

Battery Care and Maintenance Tips

• Use (3) three AAA batteries.
• Be sure to insert batteries correctly (with adult supervision) and always follow
the toy and battery manufacturer's instructions.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix new and used batteries.
• Insert battery with the correct polarity. Positive (+) and negative (-) ends must be inserted in
the correct directions as indicated inside the battery compartment.
• Do not recharge non-rechargeable batteries.
• Only charge rechargeable batteries under adult supervision.
• Remove rechargeable batteries from the toy before charging.
• Only use batteries of the same or equivalent type.
• Do not short-circuit the supply terminals.
• Always remove weak or dead batteries from the product.
• Remove batteries if product will be stored for an extended period of time.
• Store at room temperature.
• To clean, wipe the surface of the unit with a dry cloth.
Please retain these instructions for future reference.