Yamaha MX-A5200 Owner's Manual page 13

7
INPUT (XLR) jack
For connecting to a pre-amplifier with XLR output jacks (p.14).
To use the XLR jack, set the corresponding BAL/UNBAL switch to
"BAL".
When connecting an XLR balanced cable, match the pins and insert
the "male" connector of the cable until you hear a click.
XLR balanced cable (male)
• When disconnecting the cable from the unit, hold down the PUSH
button on the unit and then pull the connector out.
About the XLR jacks
• The pin assignments for the XLR jacks of the unit are shown below.
Before connecting an XLR balanced cable, refer to the instruction
manual of your pre-amplifier and verify that its XLR output jacks are
compatible with the pin assignments.
2. HOT
1. GND
3. COLD
8
INPUT (RCA) jack
For connecting to a pre-amplifier with RCA output jacks (p.14).
To use the RCA jack, set the corresponding BAL/UNBAL switch to
"UNBAL".
RCA cable
RCA short pin
L .
U N B A
B A L .
• Remove the RCA short pins attached to the INPUT (RCA) jacks before
making connections. Be sure to keep them in a place inaccessible to
small children who may accidentally swallow small parts.
• To protect against noise contamination, we recommend attaching
the RCA short pins when the INPUT (RCA) jacks are not in use.
9
BAL/UNBAL switch
Switches between XLR input and RCA input for each channel (p.14).
13
Part names and functions
En