Adjusting The Settings; Adjust Brightness - Brother AIRScouter WD-350B Installation And Operation Manual

Adjusting the settings

Adjust brightness

Press the brightness button on the side of control box to adjust the
brightness of the image on the head display. There are five levels of
brightness, and each press will increase the brightness by one level.
If the button is pressed while at maximum brightness, the brightness
will return to the lowest level.
Lock the buttons of the control box
To prevent unintentional operation, activate the key lock function by
sliding the key lock switch left.
Note
To disable the key lock function, slide the key lock switch to the right.
Reduce the size of the image
To reduce the size
of the image to more
clearly see the areas
around the edges
(for example, to ensure
that an entire scene
is in the frame), press
and hold the brightness
button.
To return the image to
its Normal size (filling
the screen), press and
hold the brightness button again.
Pressing and holding the brightness button will change the zoom mode
in the following order: Normal, Reduce, Normal...
Note
Reduce mode uses a fixed percentage to resize the image and is not
user-configurable.
Normal→Reduce
Attach the rear band
1.
Press the area highlighted in the image below, and slide the head band
cover towards the end of the band to remove it.
2.
Slide the loop at one end of the rear
band over the attachment post as
shown in the illustration, and feed
the rear band through the opening
at the end of the head band.
3.
Replace the head band cover as
shown, ensuring that the rear
band is fed through the cut-out on
the end of the cover. Press the
area highlighted in the illustration
and slide the cover back into
place.
4.
Repeat steps 1-3 to attach the other end of the rear band to the other
end of the head band.
5.
Adjust the rear band's length using the slider.