Electrical Connection; Connection To The Heater - DANHAG APP-control Operating Manual

APP-control v10.x

electrical connection

11

connection to the heater

11.1
11.1.1
heater without radio remote control
The APP-control comes with an universal connection cable. Connect the APP-
control to the power supply (red +12V, brown ground) and the yellow wire to
the control-pin of the heater.
11.1.2
heater with radio remote control
The APP-control is connected to the already existing receiver of the remote
control, using the y-cable which is included into delivery. The Y-cable also
ensures the power supply of the APP-control.
disconnect the original cable from the receiver
•
connect the y-cable to the receiver
•
connect the original cable to the y-cable
•
connect the APP-control to the Y-cable
•
An overview about the mounting place of the receiver can
be found at our website:
www.danhag.com
16 - 32