Adcon A753 User Manual page 36

R
EMARKS
R
ETURNS
R
EMOTE
E
XAMPLE
GSMPIN
D
ESCRIPTION
P
ARAMETERS
R
EMARKS
R
ETURNS
R
EMOTE
E
XAMPLE
GSMPUK
D
ESCRIPTION
P
ARAMETERS
R
EMARKS
R
ETURNS
GET only.
The command works only if no GPRS connection has been established.
If a GPRS connection has been established, use GSMSTAT instead.
The current network operator.
No.
# GSMOPER
42914 GSMOPER "T-mobile Austria" 0
#
Sets the PIN-code of the SIM-card or returns the SIM-card unlock
state.
The new PIN-code, or none (for SIM-card check).
GET/SET.
If no parameter was entered following messages may get displayed:
"Ready"
The used PIN code was accepted.
"PIN required"
No or false PIN was entered. Reenter the correct PIN-code.
"PUK required"
The false PIN was entered too often. The module has locked the SIM-
card. To open the lock. enter the PUK-code of the SIM-card. If the new
PIN-code was entered as a parameter of the command, returns the
error code.
No.
# GSMPIN
42914 GSMPIN Ready 0
#
# GSMPIN 1234
42914 GSMPIN 0
#
Sets a new PIN-code for the SIM-card or returns the SIM-card unlock
state.
The PUK-code and the new PIN-code, or none (for SIM-card check).
GET/SET.
Refer to the command GSMPIN.
CHAPTER 3
Using Terminal Commands
36