Adcon A753 User Manual page 30

FDEV
D
ESCRIPTION
WARNING
P
ARAMETERS
R
EMARKS
R
ETURNS
R
EMOTE
E
XAMPLE
FREQ
CAUTION
N
OT AVAILABLE FOR
D
ESCRIPTION
P
ARAMETERS
R
EMARKS
R
ETURNS
R
EMOTE
3 0 8 0.037200 2953 0
#
Formats the internal memory (might destroy all the data).
The chip configuration setting (first parameter of the command)
depends on the current hardware version and must not be altered.
Please contact our support team for further information.
If the parameters are missing, the command will show the current
settings. To format the internal memory (all data will be lost) with the
current settings, use 0 as the first parameter. The storage organization
(the index size only), can be optimized for your specific application.
The first parameter for this command is the chip configuration and
second parameter is the index size. The A753 factory setting is:
• 1st parameter: 256
• 2nd parameter: 10240
GET/SET.
Current memory setting.
Yes.
# 42914 FDEV
42914 FDEV 1 16+0 64..1024 384/383 9216/9192 0
#
# 42914 FDEV 1 384
42914 FDEV 0
#
Do not change the frequency of your device without reason. Apart
from the fact that it might not communicate in the network anymore,
you might also violate the applicable radiocommunications laws in
your country. Depending on the destination country, some models
may also return an error message.
GSM/GPRS-only RTUs
Sets/returns the operating frequency.
The operating frequency and step (Hz), or none in the GET version.
GET/SET.
The actual frequency and step, in Hz.
Yes, SET only.
CHAPTER 3
Using Terminal Commands
30