Advertisement
RadioNet
66
Host Card Settings
On the Host (PoleNet PC Program) go to "Select control mode" and select " Elgal", this will be
the selection for all the GaliNet – Galileo Controllers.
Go to Monitor, check that all the units are on the network and "Capture" the network according
the instructions in the RadioNet Installation Manual.
Go to Configure Controller, the Configure Elgal Cards configures up to 8 cards, from 0 to 7.
For the Galileo controller, this will be the cards on the expansion box, but in reality they will be
virtual cards.
Card definition: right clicking on the mouse at Card 0, will open a new box and virtual card
should be selected. The same for other cards that need to be defined.
empty: no card is defined.
digital 24: 24 Output card
When the cards are defined, the "Mapping" box need to be selected.
This screen has the link for assigning the Controller outputs and the RadioNet RTU outputs.
Choose the output or Input number from the virtual card that was already defined. Choose the
RadioNet unit with the output number and move it to the right box.
When the outputs and inputs assignment is complete, click on "Program" to send the settings to
the Host.
Click on the "Save" box to save the settings on the computer.
Doc. Name: RadioNet - User Manual
digital: 8 input and 16 output card
crtu: not in use with RadioNet.
Crop Management Technologies
INSTALLATION MANUAL
Revision: 01
Page: 6 of 7 pages
Advertisement
