SECOLink LT5 User Manual

Intruder alarm system
LT5 buttons
(e.g. to control gates, to trigger a panic alarm). A button must be pressed as many times as needed until the
required color light that corresponds to arming mode or programmed command appears on LED. The
button is used to send a selected arming mode or command to a receiver and pressing it minimizes the possibility
of accidental transmissions. It is also used to get
Remote control unit (RCU) template preprogrammed (programmed) in the factory:
Button
Button
turn off the alarm along with disarming.
Remote control LT5
Button
Button
ASSIGNING A REMOTE CONTROL UNIT (RCU) TO THE USER
Main Menu
1 1 Settings
Settings
2 2 Users
Users
2 2 Edit users
Advance to the next user with keypad
U01 User 01
1 1 Name User 01
keys
Choose New RCU and press
U01 User 01
Controls New RCU
6 6
Simultaneously hold down the buttons
Waiting ...
and
Message Done should appear on
Done
keypad's LCD screen when remote
control unit is enrolled succesfully.
Release buttons
Arming in Away mode:
Red = Away
W R
G B
B G
R W
Press the button as many times as
needed until the Red color light appears
on LED and then release the button.
GENERAL INFORMATION
and are used for arming and disarming, while
- this button is used for arming mode selection. Arming modes alligned by priority:
1st position = Away (color: Red);
2nd position = Night (color: Blue);
3rd position = Stay (color: Green);
4th position = Max Away (color: White).
- this button is used exclusively to disarm. If the system is signalling because of an alarm, the user will
- this button is used to clear an alarm with a single press of this botton.
- this button is used to trigger a panic alarm. Press the
or .
7 7 7 7 7 7 7 7 7 7 7
PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS
ENT ENT ENT ENT ENT ENT ENT ENT ENT ENT ENT
.
and .
Duration: ~3 sec
R
Press the button while the
Red color light is visible on LED (it
will last ~3 sec after the button is
pressed) and wait for the system to
answer.
system status.
REMOVING AN ASSIGNED USER FROM RCU
Main Menu
1 1 Settings
Settings
2 2 Users
Users
2 2 Edit users
U01 User 01
1 1 Name
.
U01 User 01
Controls Remove RCU
6 6
Waiting ...
Done
ARMING
Command sending and
battery status indication
G
R
If the system is succesfully armed in Away mode the answer from the
system will be a long lasting Red color flash on LED.
Remote control LT5
or buttons can be programmed for any task
button to avoid false panic alarms.
Advance to the next user with keypad
keys or .
User 01
7 7 7 7 7 7 7 7 7 7 7
PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS PQRS
Choose Remove RCU and press
Message Done should appear on
keypad's LCD when all remote control
unit are removed from the user.
Green (short: ~0,1 sec) = battery
G
is good
Red (short) = battery is low
R
Red (long: ~1 sec) = system is
Answer from the
R
armed in Away mode
system
No flash = no answer from the
system!
User manual
.
ENT ENT ENT ENT ENT ENT ENT ENT ENT ENT ENT
Page 1