Take Down, Storage, & Transport - Tamasu Butterfly Europa GmbH AMICUS PRIME Owner's Manual

sage directly to the Amicus Support. Also can be used for downloading and sending Exercises and
Sequences.
3. The Check For Update Button is used to check for and install the latest Amicus app. Takes only
about 1 minute on most networks. This is different than the firmware update available on the Robot
Screen.
4. Take Down, Storage, & Transport
Upon finishing your training session, power off
your robot by unplugging from power; or alterna-
tively, plug your robot into a power strip and use
the switch on the strip to turn power off.
If you're ready to remove your robot from the
table temporarily, please follow these steps:
1. Unplug the Power Supply from the outlet
and the base. Roll this cable up and place it
temporarily on your table.
2. Disconnect the rubber bands that connect your Side Nets to your table. Place the Side Nets in the
Ball Collection Tray.
3. Fold up the Net until the first stop of the folding mechanism. Unhook your robot from your table and
set it on your table with the open side facing you.
4. Place your rolled-up cable, Control Tablet, and Control Tablet Bracket in the center area of the net
on top of the balls (you do not need to remove the balls).
5. Stand your robot upright on the floor off to the side of your table or in a nearby closet. When you're
ready to train again, it's a quick, easy matter to set your robot back up on your table.
If you're removing the robot for transport or long-term storage, we recommend placing your robot
into the included Carrying Case with these additional steps:
6. Remove the cable, tablet, bracket, and balls from the center area and place those items in the
storage pockets of the Carrying Case. The Carrying Case is also a handy place to store this manual,
spare parts, tools, and other items that came with your robot.
7. Loosen the Black Knob on the rear of the Ball Tube, turn the head around 180° so it faces into the
net, and lower the head to 1 ring. Then retighten the knob. Also rotate the 2 curved tubular Support
Legs backward so they point back into the net.
8. Finish folding up the net until the two Net Corner Brackets touch and their mating Velcro pieces
adhere to one another. You may need to help the Net Uprights fold down. You can also stuff parts of
the net that are sticking out into the central part of the net.
9. Lay the robot, net side down, into the Carrying Case and secure in place with its 2 straps.
21