Calibration; The Remote Switch; Linking The Remote To The Control Tablet - Tamasu Butterfly Europa GmbH AMICUS PRIME Owner's Manual

If the Robot icon indicates a connection, there are several other functions that are available by clicking
that icon. They are discussed in below.

Calibration

All robots differ to some degree as all motors can vary from the manufacturer, but even more so as
they age. In addition, the wheels will wear differently depending upon use. Calibration harmonizes the
mechanics (the Head and Base) with the electronics (the Control Tablet). This is especially important if
the Control Tablet or Head are replaced.
To check Calibration, tap the Robot icon at bottom center. On the resulting screen, there will be a
Calibrate Button (provided there is a connection with the robot—see above). Tap this button. And then
follow the onscreen directions.
IMPORTANT: Be careful not to perform other operations with the tablet during calibration because it
can cause the app to crash and the robot to shut down, for safety reasons!

The Remote Switch

The small wireless remote has a range of 4–5 m (13–16 feet) and has the
following functions:
1. If Ball/Min on the Control Tablet is set to "0", pushing START on the
remote throws 1 ball of the Current Ball shown on the Control Tablet
(similar to Sampling a ball). For multi-ball Exercises, this means that you
can sample each Ball by repeatedly pressing the Start button to cycle
through each Ball of an Exercise.
2. If Ball/Min on the Control Tablet is not set to "0", pushing START on the
remote will cause the Exercise shown on the Control Tablet to start playing at whatever frequency
the Ball/Min is set (same as pressing Start Exercise on the Control Tablet).
3. The 2 middle buttons increase (+) or decrease (–) Ball/Min by 1 increment for each press. Or hold one
of these buttons down for rapid acceleration of Ball/Min.
4. Press the bottom red STOP button to stop ball delivery (same as Stop Exercise on the Control Tablet).

Linking The Remote To The Control Tablet

Each remote is linked to an individual Control Tablet. This linkage is done at the factory and each Con-
trol Tablet and Remote pair is kept together throughout the manufacturing process. In case you buy
more Remotes or a new one, you need to link each Remote to your Control Tablet. To start the linking
process, tap the Robot icon and in the resulting screen, touch the Learn Remote Button. The button will
start counting down from 10 seconds. During this countdown, press any one of the 4 buttons on the
remote. After the countdown has ended, the remote should be linked to the Control Tablet.
Up to 4 remotes can be linked to the same tablet. For every additional remote, a different button on the
remote must be pressed during the Learn Remote countdown.
19