Chapter 3 Operating System Installation; Os Installation Overview; Detailed Installation Steps - Lanner uCPE NCA-4020 Installation Manual

Chapter 3 - Operating System Installation
CHAPTER 3 - OPERATING SYSTEM INSTALLATION

3.1 OS Installation Overview

Figure 5 illustrates the general procedure for installing the OS.
Figure 5. OS Installation Procedure Overview
Set server boot
in UEFI mode in
BIOS
Note: DO NOT UNPLUG THE USB until the OS installation is complete!
The auto-installer takes about 30 minutes to complete. The system reboots two times during
auto-installation.

3.2 Detailed Installation Steps

1. System's MGMT port connect to the network with dhcp available.
Figure 6. Location of NCA-4020's MGMT port
2. Enter BIOS setup on the system where you want to install the OS.
3. Select 'Boot' menu.
Plugin the USB
drive with
Reboot Server
Auto-installer to
the server
MGMT Port
Select boot from
UEFI USB device
9
Select "Auto
install Ubuntu
Server xx.xx"