Advertisement
Changing Battery Modes (Mio R-1 and R-2)
Configuration Mode
The Configuration Mode enables the user to set the battery type on the Mio R-
1 and R-2 remotes to Normal for standard AAA type batteries, or Recharge if
equipped with a Lithium Ion battery pack upgrade. To enter Configuration
Mode:
Press and hold the STOP button and the INPUT button simultaneously as
1.
shown in FIG. 4 step 1. The two buttons must be pressed within 0.1 sec-
onds of each other and held down for 2 seconds. The device indicates
that you are now in Configuration Mode. See below for available modes.
Battery Type
2.
Pressing button "6" on the remote toggles the displayed battery type
between Normal and Recharge. The type of battery installed in the MIO
remote dictates the battery type to be selected.
Press the EXIT key shown in FIG. 4 step 3 when selection has been
3.
made and is reflected in the display at the top of the remote.
Note: Settings will not be lost in the event the batteries die or are removed.
NORMAL
FIG. 4
Remote "Battery Type" Programming Features
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
Display indicates battery type selected.
1. Press and hold the STOP and the
INPUT buttons simultaneously to
enter program mode.
3. Press the EXIT key when complete.
2. Press "6" to toggle between
Normal and Recharge in display.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
©2014 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
Charging The Mio Remote with the Charging Base
The Mio remotes receive power for recharging the battery pack from a charging
base. To recharge the battery pack in a Mio remote, the charging base must
first be installed correctly.
1.
Locate the power cord equipped with a power brick AC/DC converter.
2.
Connect the angled barrel power connector of the power cord into the
bottom power port on the Mio remote charging base. See FIG. 5 for the
location.
3.
Route the cable through the provided channel as shown so that it comes
out the side of the base. This will ensure that the base sits flush on a flat
surface.
4.
Connect the AC power plug from the AC/DC converter power brick to an
external power source (wall outlet, power strip, etc.)
Note: Some power supply bricks are equipped with an LED that appears very
dim when no R-series remote is present in the base. This LED lights up brightly
when a remote is in the base and charging.
5.
Place the bottom of the Mio remote into the charging base so the contacts
on the remote are on top of the charging contacts inside the charging
base. The Power LED on the Mio remote blinks red to indicate it is
charging and illuminates solid red when it is done. Full charge cycle for a
depleted battery is approximately 3 hours.
Avoid placing units equipped with AAA batteries into the charging
base.
FIG. 5
Mio Remote Charging Base (Top and Bottom view)
05/14
Rubber Feet
(Bottom View)
Angled Barrel Power Connector
(Top View)
Charging Contacts
93-0147-02
REV: E
Advertisement
