Advertisement
FDS-TP Thermal Printer
5. Button Operating Instructions
POWER (Blue LED)
OFF
ON (Always)
ON (Always)
ON (Always)
Under the normal working status, the paper feeding
begins when you press « FEED » button, and stop
when you release « FEED » button
Power off the printer, then hold down the « FEED »
button and press the power button at the same time.
Wait 2 seconds, then release the « FEED » button, the
current setting will be printed out.
Power off the printer, then hold down the « FEED »
button and press the power button at the same time.
Wait until the power indicator & « ERROR » led are
both on, and the « ERROR » led goes out, then
« ERROR » button, the density setting status, will be
printed out (it has three levels for the printing
density), the current density status is indicated
(Low – Middle – High)
September 2017 - Version EN 1.1
www.fdstiming.com
User manual
–
FEED (Red Led)
OFF
OFF
Flash
ON (Always)
Printer Status
Printer Off
Printer On, paper is present but
lid is open
Printer On, no paper present and
lid is open
Printer has paper and ready
The printer paper feed
Printer self test
Set printing density
Advertisement
