Controls - GE AEW08 Owner's Manual And Installation Instructions

Controls

Features and appearance will vary.
Lights next to the touch pads on the air conditioner control panel indicate the selected settings.
Light indicates the unit is in the
temperature or delay time Set mode.
Power
On/Off
Auto
High
Med
Low
Fan
NOTE: The display always shows the room temperature
except when setting the Set temperature or the Delay timer.
Air Conditioner Controls
Controls
Power Pad
Turns air conditioner on and off. When turned on,
the display will show the room temperature.
Display
Shows the room temperature or time remaining on
the Delay timer. Shows the Set temperature while
setting the temperature in Cool or Energy Saver
modes. The Set light will turn on while setting.
Saver mode. The Set light will turn on while
setting.
Pads
Each touch of the
pads on the unit or the
pads on the remote control will set the delay time
when using the
will turn on while setting.
Fan Speed Pads
Auto on the unit. NOTE: On the remote control,
use the fan speed
to set the fan speeds to Low, Med or High
the Auto pad to turn Auto fan on.
Mode Pad
Saver or Fan Only mode.
Note: The default temperature reading on the display is degree Fahrenheit ( °F). To change the display to degree Celcius (°C),
press the Temp Increase
to degree Fahrenheit (°F)
49-7788
+
Set
-
Cool
Fan Only
Energy Saver
Reset Delay
Mode
Filter 1-24 Hrs
Cool or Energy
timer. The Set light
Low, Med, High or
and Temp Decrease buttons together and hold for 3 seconds. Repeat the process to change back
Light indicates the
delay timer is set.
Delay
1–24hr
Delay timer
Decrease
Mode select
Fan speed
Decrease
Temperature
8
set Increase
and
Decrease
Delay ON—When the air conditioner is off, it can
be set to automatically come on in 1 to 24 hours
at its previous mode and fan settings.
Delay OFF—When the air conditioner is on, it can
be set to automatically turn off in 1 to 24 hours.
How to set:
Press the Delay 1–24hr pad on the unit or the
Delay pad on the remote control. Each touch of
the
the
control will set the timer in 1-hour intervals. The
Set light will turn on while setting.
To review the remaining time on the
timer, press the
the
control to set a new time if desired.
To cancel the timer, press the
until the light on the
Reset Filter
LED will turn on when fan has accumulated 250
pads
hours of run time as a reminder to clean filter.
Press Reset Filter to turn off the LED and reset
the accumulated run time.
Fan Fan
Remote Control
pads on the unit or
pads on the remote
pad on the unit
pads on the unit or
pads on the remote
pad goes off.
Delay
timer
Increase
Auto Fan
on
Fan
speed
Increase
power
on/off
pad
5