Advertisement
Before You Begin
Carefully unpack contents and check to make sure all parts are present. Some
assembly may be required.
TIMER
FLASH
RESET
SPEED
2
4
6
8
h
h
h
h
(1) Power Supply
(1) Remote
Transformer
(1) Ground Stake with
Attachment Screw
(1) Allen Wrench
Assembly
1. Remove battery cover from remote and install 23A battery (included).
• Please note the correct position of the battery.
• Please note that the remote control is for indoor-use only
and is not weatherproof.
2. Attach light to stake or wall mount/stand.
To attach stake (Fig.1)
a. Remove the hex screw and washer from the
stake with the included tool.
b. Use the same hex screw and washer to attach
the stake to the pivot bracket.
c. Stake to ground.
To attach wall mount/stand (Fig.2)
a. Remove the hex screw and washer from the stake
with the included tool.
b. Use the same hex screw and washer to attach the
wall mount/ stand to the pivot bracket.
c. (optional) use included screws and anchors to
mount to wall if desired.
3. Position the projector by loosening and tightening the
angle adjustment screws. (Fig.1). Stake to ground. A distance of
16-20 ft from the wall will yield about 900 sq ft.
4. Attach projector to transformer by fully inserting the two-pronged plug
and tighten the wire cap. (Fig.3)
5. Plug unit into a 120VAC/60Hz power outlet (Caution: The Elf Light will
turn on once it is plugged in. Up to 30 minutes warm-up time may be
necessary for conditions below -15°F. Following precautions for laser
usage on page 3, re-aim if necessary).
(3) Screws &
(1) 23A Battery
Anchors for optional
wall mounting
(1) Wall Mount/Stand
(1) Light Projector
(4)
Stake screw
Angle
adjustment
Angle
Angle
screw
adjustment
adjustment
screw
screw
Fig.1
Fig.2
Remote Guide
Retractable Antenna
LED Indicator
Power On/Off
Battery Installation
on back of remote
Operation
1. Power ON/OFF – The Elf Light will default to turn on when
plugged in. Pressing the power button will turn the lights OFF
and will be in standby mode. Timer settings are retained in
standby mode until the device is unplugged. To turn the lights
back on, simply press the power button.
2. Color select (multi-color versions only) – Pressing this button
will cycle between the colors (for multi-color versions only).
Pressing this will select one color to turn on.
Press again for the other color to turn on. Press again to have
both colors work. Note: Certain surfaces reflect colors better
than others. For instance, a green laser reflects off of leaves
better than red lasers.
Angle
adjustment
screw
Stake screw
Fig.3
Color Select
Flash Mode
Timer/Reset
TIMER
FLASH
RESET
Flash
Speed
SPEED
Timer
2
4
6
8
h
h
h
h
(5)
PAGE 5
Advertisement
