Honda CBF600S 2006 Owner's Manual page 121

Installation Notes:
To install the rear wheel, reverse the removal
procedure. Torque the axle nut to the
specified torque.
Axle nut torque:
93 N•m (9,5 kgf•m)
When installing the wheel insert the brake disc
carefully between the pads, taking care not to
damage them. Also take care not to damage
the ABS sensor (if present) on the rear caliper.
(CBF600SA/NA)
After installing the wheel, apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the brake
drags or if the wheel does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
107