EMS FireCell FCX-100-101 Installation Manual

Wireless Detector c/w Remote Indicator
Installation Guide
www.emsgroup.co.uk
Radio Detector Base
IDENT
PRESS HERE TO
LOG ON
1 Pre Installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed
device. This will cause communication with the Control Panel
to be lost. Should this happen, delete the device from the
system and add it back on.
3 Fix Mounting Plate
Remove the mounting plate from the wireless module, by turning
it anticlockwise.
Use both mounting holes to ensure a firm fixing.
Use suitable fasteners and fixings.
5 Optional Device Locking
To lock the detector into
the wireless module,
insert a 1.5mm Allen key
into the allen key slot and
turn clockwise as shown.
To unlock, insert a 1.5mm
Allen key into the Allen
key slot and turn
anticlockwise as shown.
©2018 EMS Ltd. All rights reserved
Example shown:
Model FCX-100-101
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
63mm
Part No Product Description
FCX-100-101 Optical Smoke Detector & Remote Indicator Unit
FCX-120-101 Heat A1R Detector c/w Remote Indicator Unit
FCX-120-111 Heat CS Detector c/w Remote Indicator Unit
FCX-170-101 Wireless Detector Base c/w Remote Indicator Unit
5-RIM Remote Indicator Unit Only
See the Specification section for compliance information.
2 Components
Remote Indicator Unit
1 2
1
Fixing Screws 2
5
Detector 6
Wireless Module inc 300mm cable
4 Power Device
OBSERVE CORRECT POLARITY, USING SPECIFIED BATTERIES.
If fitting / re-fitting batteries; observe correct polarity, using
only specified batteries.
Connect the power jumper across the PIN header.
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
SIZE AA
Once powered, reassemble the device.
6 Configuration
The device's loop address is configured within the menu structure
of the Radio Hub.
Refer to the programming manual (Doc Ref: MK98) for full
programming information.
Page 1 of 2
Wireless Detector
3 4 5
3
Mounting Plate
Front Cover
unpowered
(pins unlinked)
device
powered
(both pins linked)
Free to download from
www.emsgroup.co.uk
TSD033 Iss 3 05/09/2018
CPR
[2][3]
[1][3]
[1][3]
[3]
6 7
4
Dust Cover
7
Mounting Plate
device
AJM