Physically Connect Your Printer; Chapter Iii: Connecting Your R1 3D Printer - Robo 3D R1 Manual

CH III
Connecting your R1 3D Printer

Physically connect your printer


Locate a solid flat surface to place your printer- somewhere close to your computer

You also need to be close to a power outlet

Plug the USB cable that comes with your kit into the right side of the printer and
connect the other end to an available port on your computer.
*
IMPORTANT!! Make sure you set the voltage on the power supply on the back
side of your printer to the correct position before use! Use a flat head
screwdriver or a pen to move the slider. Use 115 (3.1a) if you are in the U.S. If
you are out of the U.S. or need a higher voltage setting for another reason, move
the slider to the 230v (3.1b) position.

Flip the switch on the back right side of the printer to the on position (3.2)
(3.1a)
(3.2)
(3.1b)
4