Assembly Instructions - Jacobs Ladder 2 Owner's Manual

Take the following steps to assemble the Jacobs Ladder 2.
1. Unpack the ladder and remove the packing materials from the base and upright/console
assembly.
2. Unbolt the ladder from the pallet and roll it on to the floor.
CAUTION: To avoid injury and ensure your safety, be sure to get the appropriate
number of people to help you move the ladder to its final location. A fully assembled
Jacobs Ladder 2 is very heavy and you might injure yourself if you move the ladder
improperly.
If you need to move the ladder, ask for assistance. Roll the ladder on its rear transport
wheels to its new location by slowly tipping the ladder back to engage the wheel. Be sure
to have assistance as ladder is heavy. Additional help supporting the front end of the
ladder will improve the ease of movement.
Make sure that the ladder is unplugged. Do not assemble the ladder if it is plugged into a
power outlet.
3. Once in its final position, use a 5/8" wrench to remove the two nuts/bolts located at the
bottom base of the ladder, holding the transport wheels in place. Keep both bolts and
nuts, as they will be reused. Remove the transport wheels and store for future use.
4. Install the Ladder support feet in
the location where the wheels were
removed. Two 3/8" bolts should be
installed through the main base into
each of the two support feet. Each
foot should be located in the same
center section where the wheel was
previously removed. A 3/8" nut should
be installed on the end of the bolt
as it projects through the opposite
mounting wall of the main base. Tight-
en each nut to ensure no movement
occurs in the feet.
Jacobs Ladder LLC

ASSEMBLY INSTRUCTIONS

5
jacobsladderexercise.com