Advertisement
Accessory
IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
Assembly Instructions...
1
3
5
How to care for your Childcare Accessory Cot Bed Rail
Maintenance
Always check parts regularly for tightness of screws, nuts and other fasteners – tighten or replace if
required. To maintain the safety of your Accessory Cot Bed Rail seek prompt repairs for bent, torn, worn
or broken parts. Use only those parts and accessories approved by CNP Brands.
Distributed in Australia by CNP Brands
20 Calarco Drive,
Derrimut, VIC, 3030
Customer Service 1300 667 137
W: www.cnpbrands.com.au
E: info@cnpbrands.com.au
F: www.facebook.com/CNPBrands
I: @cnp_baby
1a.
Remove two filler bolts and
blanks from End Panel.
1b.
Repeat for the other End
Panel.
3a.
Remove Drop Side Panel
by pushing the End Panel
outwards while sliding the pin
from the lower track first and
then the top pin.
3b.
Repeat for the other End
Panel.
5a.
Position Bed Rail (smooth side
out) between the End Panels
and insert the long bolts
through the End Panels.
5b.
When all bolts are partially
tightened, finish with Allen key
until firm.
Accessory
2
4
6
Distributed in New Zealand by Wainhouse Distribution
2-6 Argyle St, Morningside,
PO Box 41-014,
St Lukes, Auckland, New Zealand
Customer Service: 0800 567 5000
E: helpline@wainhousedist.co.nz
Cot Bed Rail
MODEL # 091203
2a.
Loosen Mattress base bolts
but do not remove.
4a.
Insert four Barrel Nuts into
the holes on the side of the
Bed Rail with the slot facing
the end of the Bed rail (see
below).
6a.
Re-tighten the Mattress base
bolts.
Your Toddler Bed is ready for
6b.
use.
Advertisement
