Q-See QCW3MP16 Quick Start Manual page 3

STEP 2
Plug the power adapter into a surge protector and
plug the micro USB end of the cable into the camera
and wait until the indicator light begins to flash. After
15-30 seconds the light should slowly flash green
which indicates it is ready to configure. If the light
displays red, hold the reset button for 15 seconds to
reset the camera.
IMPORTANT: Go through all of the steps to setup
and test your system before mounting your camera.
Visit www.q-see.com/support to find the most
recent guides and up-to-date support for your
Q-See products.
STEP 3
Download the Q-See Plus app
from the App Store on your mobile
device. Once installed, ensure that
your mobile device is connected
to the Wi-Fi network you wish to
use for your camera. Launch the
app on your mobile device.
STEP 4
Tap on Register and
create an account for
the new camera.
*All screenshots shown
are from the Q-See Plus
app on Android.
3