Layer 3 Network - Configure Route Scopes - Fortinet FortiNac BFN620 Installation Manual

Layer 3 Network - Configure Route Scopes

Layer 3 Network - Configure Route Scopes
The configuration views for the Isolation, Registration, Remediation, Dead End, VPN and
Authentication scopes are similar. The Access Point Management scopes configuration view
contains sections for both Production and Isolation clients. Sample Isolation and Access Point
Management views are shown below.
For each set of route scopes you are configuring:
Click
1. Next
displayed type or select the type from the left-hand navigation pane.
2. To configure the route scopes displayed, select the
as Isolation or Registration, and enter the required information. See the table below for
definitions of the fields.
3. Click Add
4. Enter the Label, Gateway, and Mask.
5. In the Lease Pools section, click
6. Enter the IP Addresses for
7. Repeat steps 3 through 6 to create additional scopes and lease pools.
8. In the Isolation IP Subnets section, enter the list of IP Addresses and corresponding
Subnet Masks indicating IP addresses for which FortiNac will serve DNS.
9. For the Access Point Management
Mask.
10. Enter the Access Point Management Scopes and Lease Pool information. Add or
modify scopes and associated lease pools.
Enter the
11.
Click
12. Next
Field
Route Scope Interface eth1
Interface IP
Address
Mask
30
to proceed to the next configuration screen if you are not configuring the
to add scopes or Modify
Start
information in both the
Domain
when finished.
Table 15: Layer 3 Isolation Field Definitions
Definition
IP address for the Route Scope interface on eth1. Use a different IP for each route
scope type you configure.
The subnet mask for the interface IP address. Note that the mask is shared between
route scope types. If you modify the mask in one route scope, it changes in all others.
check box
to change existing scope information for this route.
Add to add the lease pool information for the scope.
and End of the lease pool range, then click
scopes, enter the Interface IP Address and
Production
next to the name, such
Add
and sections.
Isolation
.