Layer 3 Network - Route Scopes - Fortinet FortiNac BFN620 Installation Manual

Layer 3 Network - Route Scopes

Figure 14: Summary Of Layer 2 Network VLAN Configuration
Layer 3 Network - Route Scopes
If you are configuring the appliance in a routed environment, as opposed to a Layer 2
environment, use the Layer 3 selection on the Network Type window. See Network Type on
page 20. Instead of trunking VLANs on eth1, eth1 is connected to a single VLAN on an untagged
port. Network traffic is routed to the clients rather than the clients connecting on the local Isolation
VLANs.
Multiple scopes are allowed for each of the routes (Registration, Remediation, Dead End, VPN,
Authentication, Isolation, and Access Point Management). Within these scopes, multiple ranges
in the lease pool are also permitted. In addition you can add static routes. See Layer 3 Network -
Additional Routes on page 40.
If you are not configuring routes at this time move to another step by doing one of the following:
select the step from the list on the left or click in each route screen. Re-run the
Next
Configuration Wizard to configure routes at a later time.
28