GE PVW7301 Installation Instructions Manual page 4

Z
O
g
Z
O
i
_J
_J
Z
i
Installation Preparation
TOOLS AND MATERIALS REQUIRED
(NOT SUPPLIED)
Pencil and tape measure
Safety glasses
Phillips screwdriver
Level
Electric drill with #2 Phillips,
flat head, and 9/32" drill bit
Wire cutter/stripper
Aluminized
Duct tape
UL listed wire nuts
©
Strain relief for
junction box
REMOVE THE PACKAGING
A CAUTION:
Wear gloves to protect
against sharp edges.
, Remove the duct covers.
. Remove the hardware bag, literature package
and other boxed parts.
. Remove and properly discard the protective
plastic wrapping and other packaging materials.
PLAN THE INSTALLATION
A CAUTION:
To reduce risk of fire and to
properly exhaust air, be sure to duct the air
outside - Do not vent exhaust air into spaces
within walls or ceilings or into attics, crawl spaces,
or garages.
PARTS SUPPLIED FOR INSTALLATION
.1 Hardware Package
,1 Literature Package
PARTS NEEDED FOR INSTALLATION
, i Strain Relief
, Power Supply Cable
, i Wall or Roof Cap (for ducted venting only)
, All Metal Ductwork (for ducted venting only)
, Recirculation Duct (for recirculation install only)
WARNING:
PERSONAL INJURY HAZARD
Because of the weight and size of the rangehood
canopy. It is recommended that 2 people are used
to install the range hood. Failure to properly lift
rangehood could result in damage to the product
or personal injury.
NOTE: This rangehood can be installed as either
ducted or recirculation. In a ducted application,
this rangehood can be vented through the wall
or ceiling. When installed for recirculation, the
rangehood vents out the sides of the duct cover.
NOTE: Before making any cuts or holes for
installation, determine which venting method will
be used and carefully calculate all measurements.
- 31 11007