Related Manuals for EXTERIS AUDIO EA200SW
Summary of Contents for EXTERIS AUDIO EA200SW
- Page 1 Outdoor Audio Solutions: Unique Outdoor Speakers & Stereos OWNER’S MANUAL Model EA200SW Hardwired Outdoor Stereo Speakers www.ExterisAudio.com Copyright © 2011-2017 Exteris Audio, LLC All Rights Reserved.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Specifications Drivers per Speaker: Design Features..............1 Tweeter 1 - 1” Titanium dome / ferrofluid cooled Introduction................2 Woofer - upper 1 - 6.5” Polypropylene cone with rubber Install Location..............2 surround Cautions................2 Woofer - lower 2 - 6.5”... -
Page 3: Design Features
Model EA200SW Model EA200SW Design Features damage in transit. If original shipping containers are not available, the Front View appropriate packaging can be ordered by calling us. This Warranty is not transferable and does not cover product purchased, Titanium Dome Perforated serviced or used outside the United States. -
Page 4: Introduction
5 Years – Speaker cabinet glue joints and attached cabinet hardware, e.g. terminals, bass ports, recessed handles, As with all our speakers, EA200SW’s will look and sound great if you etc. Stone veneer is not warranted against naturally choose to use them indoors as well. -
Page 5: Contents
Model EA200SW Model EA200SW Maintenance Contents In addition to the four cabinets, you will find the following items included Your new speaker system is made of very rugged materials and that will be needed to complete assembly and install: components to ensure years of trouble-free performance. However, in order to extend the “like-new”... - Page 6 (2) aluminum base supports. Remove for later installation. Model EA200SW speakers are designed to be connected to an external /indoor stereo amplifier as noted in Fig. 9. If speaker wires are to be run Note: All remaining parts for assembly/install will be located in a through walls, please check local building codes for appropriate wiring to separate small parts box.
- Page 7 Model EA200SW Model EA200SW each of the right and left tower arrangements. See Fig. 8 for 6. From boxes with cabinets B,D remove the top four (4) foam corner details. protectors and place two (2) in the up position on a solid surface.
- Page 8 Model EA200SW Model EA200SW 2b. Install eight (8) ea. alignment pins into top of cabinet B and D as 5. Move cabinet A and C to install location and mount to cabinet B shown in Fig. 5. and D. 5a. Using the recessed handles in the backs of cabinets A and C, NOTE! Be very careful to install ONLY 1/4”...
Need help?
Do you have a question about the EA200SW and is the answer not in the manual?
Questions and answers