Winegard ConnecT WF-AP01 Quick Start Manual

Winegard ConnecT WF-AP01 Quick Start Manual

Hide thumbs Also See for ConnecT WF-AP01:

Advertisement

WINEGARD

Quick Start Guide

Before using your Winegard ConnecT WiFi extender, there may be some additional steps required to set up your Winegard
NOTE:
ConnecT extender for use. If you have further questions, consult the full installation guide.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following methods:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and devices.
• Connect the equipment into an electrical outlet on a circuit different
from that which the radio receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ConnecT
®
www.winegard.com/connect
FCC Caution
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
this equipment.
Only channels 1–11 can be operated. Selection of other channels is
not possible.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set
forth
for an uncontrolled environment. This equipment should be
installed and operated with a minimum distance of 25 cm between the
radiator and your body.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance
with FCC multi-transmitter product procedures.
Manuel disponible en français
au www.winegard/support
2452375
Rev0 8/16

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ConnecT WF-AP01 and is the answer not in the manual?

Questions and answers

Summary of Contents for Winegard ConnecT WF-AP01

  • Page 1: Quick Start Guide

    Manuel disponible en français au www.winegard/support www.winegard.com/connect Before using your Winegard ConnecT WiFi extender, there may be some additional steps required to set up your Winegard NOTE: ConnecT extender for use. If you have further questions, consult the full installation guide.
  • Page 2 SYSTEM SET UP Figure 1 Turn on the WiFi enabled device that you want to connect and scan for wireless networks with this device. The label on the back of the indoor unit (IDU) will display the default SSID. Select this WiFi signal and connect. Once the default network has been selected, enter the password found on the back of the IDU.

Table of Contents

Save PDF