Connecting The Cables - Samsung SW-208 User Manual

Connecting the Cables

1
Connecting the power cable
The 4-pin power cable from the internal power unit of your computer must be
connected to the power terminal on the rear of the CD-R/RW drive.
2
Installing a jumper on the master/slave select terminal
Install the jumper in the correct position on the terminal:
MA to use the device in the master mode
SL to use the device in the slave mode
CS to control the device via a CSEL
host interface signal
See Step 3 for further details.
3
Connecting the IDE cable
Two configurations are possible.
The CD-R/RW drive is the only IDE device in addition to the hard disk.
IDE port
Mother board
Hard disk
CD-R/RW
(SL)
Install the jumper in the SL position (Slave).
Connect the 40-pin flat IDE cable from the IDE port on the mother board, first to
the CD-R/RW drive and then to the ha r d disk
6
1. Power cable
2. Master/slave select terminal
3. IDE cable
4. Audio cable
(MA)
.
You already have an additional IDE device installed in your computer.
Second IDE cable First IDE cable
Mother
board
CD-R/RW CD-ROM
Hard disk
(MA) (SL)
Install the jumper in the MA position (Master).
Connect the 40-pin flat IDE cable from a second IDE port on the mother
board directly to the CD-R/RW drive or first to another additional IDE drive
and then to the CD-R/RW drive.
4
Connecting the audio cable from a sound card
Connect the 4-pin audio cable between the sound output terminal on the CD-R/RW
drive and the audio input terminal on the sound card.
7
Hard disk
(SL) (MA)