Table of Contents
Advertisement
ELECTRICAL REQUIREMENTS & WIRING DIAGRAM
WARNING
Electric Shock Hazard
Disconnect power before
servicing.
Replace all parts and panels
before operating.
Failure to do so can result in
death or electrical shock.
Before plugging in the water heater, always make sure:
•
The voltage and frequency correspond to that specified
on the water heater wiring diagram.
•
The electrical outlet has the proper overload fuse or
breaker protection.
1. The unit must be connected to a 120VAC power
supply. A dedicated circuit is preferred.
2. The water heater must be properly grounded.
3. This water heater is a polarity sensitive appliance and
will not operate properly if the power supply polarity
is reversed.
4. Do not use a GFI outlet.
Note: Always reference the wiring diagram for the correct
electrical connections.
After making all electrical connections, completely fill the
tank with water and check all connections for leaks. Open
the nearest hot-water faucet and let it run for 3 minutes to
purge the water lines of air and sediment and to ensure
complete filling of the tank. The electrical power may then
be turned on. Verify proper operation after servicing. See
also "Installation Checklist".
Figure 12.
100221773_2000189439_Rev. 01
CAUTION
LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN
SERVICING CONTROLS. WIRING ERRORS CAN
CAUSE IMPROPER AND DANGEROUS OPERATION.
VERIFY PROPER OPERATION AFTER SERVICING.
POWER VENT WIRING SCHEMATIC.
NOTE: REFER TO THE "Installation Checklist"
BEFORE OPERATING THIS HEATER.
6
3
5
2
P1
4
1
4
3
P2
2
1
4
2
P3
3
1
P4
www. lochinvar .com
1
N
1
L1
EARTH GND
CAPACITOR
4
BLOWER
7
FLAME SENSOR
6
HOT SURFACE IGNITER
5
PRESSURE SWITCH
3
HIGH LIMIT SWITCH
2
FLAMMABLE VAPOUR SENSOR
Circled numbers indicate
sequence of operation.
Figure 13.
13
Advertisement
Table of Contents
