Troubleshooting; Self Diagnosis Display - Samsung VP-MM10S(BL) Owner's Instruction Manual

ENGLISH

Troubleshooting

Self Diagnosis Display

Display
Not enough free space
Corrupted file
Paper error
Ink error
File Error
Communication Error
Low battery
Holding the key
Card error
Not formatted
Write error
Read error
Not supported format
Write protected
MPEG decoding Error
If these instructions do not solve your problem, contact your nearest Samsung dealer or authorized service centre/personnel.
✤
Symptom
No power is supplied
Date/Time is wrong
Focus does not adjust automatically
The memory card will not load
properly
130 130
Informs that...
Not enough free space for saving files .
The file is corrupted.
Paper has run out.
Ink is low.
The file is wrong.
An error has occurred while transferring data.
Battery is low.
The HOLD switch is locked.
The memory card is corrupted.
Format the memory card.
Failed to write.
Failed to read.
The format is not supported.
Memory card is protected to write.
The movie file is corrupted.
Possible Causes
The power is not connected properly
The battery is dead
The battery is too cold
The Date/Time is not set
Focus is set to manual mode
Recording is being done in a dark place
Lens is covered with condensation
The memory card is in wrong position
A foreign object is in the memory card slot
Check the space of internal memory or the external memory.
Delete the corrupted file.
Check the paper in the printer. If there is no paper, insert the paper.
Check if the ink or toner is low.
Check that the file is JPEG.
Disconnect the USB cable and connect it again.
Charge the battery pack or connect the AC Power Adapter.
Unlock the HOLD switch and operate the Memory Camcorder.
Format the memory card or replace it with a new one.
Format the memory card.
Check the memory space or format the memory.
Delete the file.
The AVI or JPEG file that is not supported. Check the supported
file. on page 29.
Unlock the memory card. (except MMC)
Delete the corrupted file.
Connect the AC Power Adapter properly, page 24
Replace the dead Battery Pack
Warm up the battery or move to warmer place
Set the Date/Time, page 103
Set focus to AUTO
Use the flash or light the location
Clear the lens and check the focus
Insert the memory card properly, page 33
Clear the memory card slot
Action
Measure