Testing Signal Strength; Deleting Transmitters; Adding Daughterboard’s; Using Cm-Rfct Cable Tool - CAMDEN Lazerpoint RF RX-92 Installation Instructions Manual

Step 5

Testing Signal Strength

By setting Dip Switch #4 to ON, you can display the signal
strength of the transmission from a TX-9 transmitter. The
benefit is the installer will be able to determine that the
transmitter or receiver is in the best possible location and
that the transmission is not being hindered by possible
interference.
To display signal strength, set Dip switch #4 ON.
Activate the transmitter, and observe the number of flashes
of LED 1. One or two RED flashes indicates poor reception,
and it is suggested to move the transmitter or receiver until
3 to 5 GREEN flashes are observed. Sometimes moving the
transmitter only a few inches one way or another will make a
significant difference. Four or five flashes are ideal.
Step 6

Deleting Transmitters

Pressing and holding either PB1 or PB2 for 8 seconds will
delete all transmitters. The LED Array will flash rapidly for
4 seconds to indicate erasure of the codes. Note that
individual removal of specific codes is not possible at this
time.
Step 7
Adding Daughterboard's
A unique feature of Camden's Lazerpoint RF is the ability
to add one or two daughterboard's, extending compatibility
to older technologies. This ability to work with additional
frequencies also allows the user to utilize hand-held
transmitters as well as wall-switch-ready transmitters.
The daughterboard's may be factory or field installed. Please
see Drawing DRG-RX-DB (page 12) for detailed installation
instructions.
!
Remember to take reasonable care to avoid static
electricity whenever handling circuit boards.
Lazerpoint™ RF RX-92 Full-Function Receiver Installation Instructions
The daughterboards may be identified by the model number
and antenna colour, as shown in the chart below:
Once installed, the learning of transmitters on above
frequencies is identical to the TX-9 transmitter. Also, the
40 code memory limit includes all transmitters, even those
learned in on the daughterboards.
Step 8

Using CM-RFCT Cable tool

Since the LED's may be difficult to see once the RX-92 is
installed, a 33" long plug-in cable tool is available.
The CM-RFCT Cable Tool plugs into the opening on the side of
the receiver, and allows the installer to view LED's mounted
on the free end. Pairs of LED's mounted on both sides of the
cable increase visibility.
Display status is dependant on Dip switch 4 setting. Turn OFF
to view relay status, and turn ON to view the Signal Strength.
When installation is complete, simply unplug the cable tool,
coil and save for another job.
!
Model # Frequency
RX-DBB 300 MHz
RX-DBO 318 MHz
RX-DBR 390 MHz
RX-DBW 433 MHz
Antenna
Blue
Orange
Red
White
Page 3 of 13