Advertisement
Step 6
Using CM-RFCT Cable tool
Since the LED's may be difficult to see once the RX-91 is
installed, a 33" long plug-in cable tool is available.
The CM-RFCT Cable Tool plugs into the opening on the
side of the receiver, and allows the installer to view LED's
mounted on the free end. Pairs of LED's mounted on both
sides of the cable increase visibility.
Display status is dependant on Dip switch 4 setting. Turn
OFF to view relay status, and turn ON to view the Signal
Strength.
When installation is complete, simply unplug the cable tool,
coil and save for another job.
Section 4
Technical Data
Model
Frequency:
Codes
Size
Mounting
Switch Connection
Built-in Piezo sounder
Power
Battery life
Range
Temperature rating
Model
Size
Mounting
Enclosure
Operating voltage
Current Draw
Response time
Lazerpoint™ RF RX-91 Basic Receiver Installation Instructions
TX-9 Transmitter
Operates in the 902 – 928
MHz ISM Band
1 million unique (20 bit) codes
2 ¼" L x 5/8" W x 3/8" H
Double sided foam tape
2 x 10" leads with ¼" quick
disconnect terminations
Used for Low Battery status,
Battery Gauge™, and Stuck
Switch indicator.
2 x AAA alkaline batteries
Minimum 500,000 operations
Over 500 ft (open area)
-40 to 185 F (-40 to +85 C)
RX-91 Receiver
3 ½" L x 2" W x 1" H
2 # 8 screws at 4" centers,
or Velcro (supplied)
Clear plastic case
12 / 24 Volts, AC / DC
23 mA nominal @ 24 VAC
63 mA maximum @ 24 VAC
+ 5 mA per RF module
30 – 200 ms
Memory
LED's
Output
Relay contact rating
Time Delay
Electrical Life
Temperature rating
Certifications
Accessories:
Plug-in daughterboard's extend capability with other
frequencies. Refer to the following chart:
Daughterboard
Optional
Model
Frequency
RX-DBB
300 MHz
RX-DBO
318 MHz
RX-DBR
390 MHz
RX-DBW
433 MHz
CM-RFCT – A 33" long cable-tool for high visibility of
relay status and signal strength
Section 5
Warranty
Camden Door Controls guarantees the Lazerpoint RF
(TX-9, RX-91,or RX-92 models) to be free from manufacturing
defects for 3 years from date of sale.If during the first
3 years a Lazerpoint RF component fails to perform correctly,
it may be returned to our factory where it will be repaired
or replaced (at our discretion) without charge. Except as
stated herein, Camden extends no warranties expressed
or implied regarding function, performance or service.
NOTE: Batteries are exempt from this warranty!
40 transmitters
Indicate: relay status; signal
strength; learn mode;
erase mode &
potentiometer position
1 x SPDT relays
3 amps @ 30 VDC
1 – 30 seconds
1 x 10
minimum
5
-40 to 185 F
(-40 to +85 C)
·FCC Part 15 Compliant
·Canada RSS CNR210:1078
1032 061A
·Meets: IEC60601-1-2:2007
Patent Pending
Antenna
Colour
Blue
Orange
Red
White
Page 3 of 7
Advertisement
