Hitachi Compute Blade 500 Installation Manual page 20

(2)Connect to the 10G DCB switch module.
Connect to the 10G DCB switch module for the operation on 10G DCB switch
module with the procedure of each Compute Blade Server as followings.
The user ID and the password of 10G DCB switch modules shipped from the
factory are set as below. Please use these information, if needed.
<< System Console Main Menu >>
P. Start OS console session.
SW. Start switch module console session.
S. System command mode.
X. Exit.
(P,SW,S,X) : SW
Select switch module (0-5,[Q=Quit]) : 5
Confirm? (Y,[N]) : Y
Network OS (VDX6746)
NOS Version x.x.x_xxx
sw0 login: admin
Password: xxxxx
WARNING: The default password of 'admin' and 'user' accounts have not
been changed.
Welcome to the Brocade Network Operating System Software
admin connected from 127.0.0.1 using console on VDX6746
sw0#
(0)$ change console -s 0 –F
Welcome to the Brocade Network Operating System Software
ssouser$ connected from 127.0.0.1 using console on sw0
sw0#
2-8
Hitachi Compute Blade Embedded 10G DCB Switch Module License Installation Guide
Item
user ID
password
 Enter SW
 Enter Y
 Enter User ID of administrator (admin).
 Enter Password
Compute Blade 2000
↑ Enter slot number (0,1,2 or 3.See Note1)
Compute Blade 500
Factory settings
admin
password
 Enter slot number
Preparations