Black & Decker 2683-220 Instruction Manual page 8

154577/2683-220 IC 5/17/02
Figure 2
BLADE LOCK
BRUSH
INSPECTION
CAP
Figure 4
DEPTH
ADJUSTMENT LEVER
1:47 PM Page 6
Figure 3
TIGHTEN
LOOSEN
MOVE TO
Figure 5
DESIRED DEPTH
OF CUT
Figure 6 TIP OF TOOTH
GULLET
SURFACE OF
WOOD
7. Confirm the accuracy of the setting by checking the squareness of an
actual cut on a scrap piece of material.
ADJUSTING THE SHOE PARALLEL TO THE BLADE
Your saw is adjusted at the factory so that the blade and shoe are parallel. If
these parts become misaligned, adjust as follows:
1. TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
2. Loosen the 2 screws at the adjusting bracket at the rear of the shoe, as
shown in Figure 11.
3. Adjust the shoe until it is parallel to the blade by measuring from the
edge of the shoe to the blade, front & rear. You can measure from the
outside edge of the blade to the shoe as shown in Figure 11 or from the
the inner edge of the blade to the wider part of the shoe. (Do not measure
from the tips of any saw blade teeth.)
4. When the shoe is parallel, tighten all screws.
6
QUADRANT
Figure 7
LEVER OR
KNOB
QUADRANT
KERF INDICATOR