Parameter Remote Control - E-RM Multiclock User Manual

Parameter Remote Control

In addition to control shift and shuffle amount on the respective
knobs, those parameters can also be changed and read remotely
over USB using MIDI commands. To enable this feature, switch
Remote
in the advanced settings to your desired USB MIDI port.
To send a snapshot of the current parameter settings to your DAW
you need to lock the respective channel. Channels are locked by
pressing set channel and the respective channel number during
playback.
All current channel settings are then transmitted over USB MIDI
and the channel number on the home screen changes to
This snapshot can be recorded and replayed to the multiclock
each time you want the same shift and shuffle settings again. De-
tails on the snapshot structure can be found in the table below.
Please note that all controls can also be sent independently.
Remote function
Controlled sync channel
Shift amount
Shuffle amount
Start channel
Stop channel
When the multiclock has received a snapshot or your own automa-
L
tions, the on the homescreen changes to
operation.
To exit remote operation and return to the knobs, simply unlock
the channel by pressing set channel and the respective channel
number during playback again.
MIDI Command
MIDI Channel
0xEn 0xvv 0xuu
Pitch Bend
0xBn 0x01 0xww
Mod Wheel (CC1)
0x9n 0x24 0x7F
Note #36 On
0x9n 0x26 0x7F
Note #38 On
R
to indicate the remote
Enable MIDI Remote Control
Refer to section 3.3.1 (p. 11) for
further information on channel lock.
L
.
USB MIDI Remote Control Implemen-
tation. Shift uses the top 12 bits of
n=1-4
uuvv
, shuffle uses
u s i n g u s b m i d i 21
ww
from 0-99.