advanced recording
Using the touch point function
Using the Touch Point function, you can have the camcorder focus on a small
section of the picture. You get the camcorder to focus on a particular point by
touching the desired point on the LCD screen.
To activate the touch point with a long touch
You can activate touch point by lightly pressing a particular point on the LCD
screen for about 2 seconds.
•
The Auto Focus (AF) setting is useful when you operate the zoom function because you might not be able to keep
accurate focus after the zoom ratio has been changed.
•
In the manual focus setting menu screen, you can access auto focus by touching the AF (
You can return to manual focus by touching the manual focusing tabs.
•
If you have enabled the Touch Point function, you can reset the focus to Auto by touching the AF
(
) tab on the LCD screen.
Anti-Shake (OIS: Optical Image Stabilizer)
Smart OIS improves on existing Optical Image Stabilization by allowing the camcorder lens to shift
over wider range of motion in wide/tele zoom position. This allows the camcorder to compensate
for greater degrees of camcorder shake and delivers a stunning level of image smoothness.
PRECHECK!
Select the record mode by pressing the MODE button. page 24
1. Touch the Menu (
2. Touch the desired submenu item.
3. To exit the menu, touch the Exit (
Submenu items
•
Off: Disables the function.
•
On (
) : The Anti-Shake(OIS) function is enabled to compensate for shaking.
Use the Anti-Shake(OIS) function in the following cases
•
When recording while walking or riding in a moving car.
•
When recording with the zoom function.
•
When recording subjects of a small size.
58
) tab "Anti-Shake(OIS)."
) or Return (
STBY
OFF
OFF
SUPER
SUPER
1/1
) tab.
00:00:00
[307Min]
9999
) tab on the screen.
Anti-Shake(OIS)
Off
On