Table of Contents
Advertisement
I
3. To change programs, push and release the
program selector button. Each time this
button is pushed and released, the next
program will play. If button is not pushed,
programs will play in succession, auto¬
matically and continuously.
4. To turn tape player off, pull cartridge out
approximately one inch from its seated
position. Never allow cartridge to remain
seated when tape player is not in use. Store
tapes in a cool area (in their containers)
with the open (tape) end down. Protect
tapes from direct sunlight and dust.
In time, oxide from recording tape will
accumulate on the tape head and capstan
shaft which can cause tape hiss and erratic
operation. The more often the tape player is
used, the more often it should be cleaned.
Clean the head with a cotton swab moistened
with isopropyl alcohol. Do Not Use carbon
tetrachloride.
To clean the capstan shaft, first turn on the
motor by depressing the motor switch (next
to the capstan shaft) with the eraser end of a
pencil. Use a cotton swab moistened with
alcohol on the shaft.
Fuses for the radio, tape deck and main radio
line are located behind the central control
panel.
The Bay Breeze Airconditioner has a high and
low speed setting. To operate: (1) Close door,
windows and ventilators. (2) Set thermostat
to desired temperature (75° is normal). Do
not make frequent changes. (3) Set the fan
Air Conditioner Ducts and Filter
switch (left under thermostat) to "HI" posi¬
tion. (4) Set main switch (right under thermo¬
stat) to "cool." When the inside temperature
is 90° or less and expected to continue, set
speed to "LO." To shut down: Set main
switch to "OFF."
Shut off to
clean or replace the filter.
Remove, brush
off loose lint, run water
through filter or move it briskly in soapy
detergent
water.
Rinse
thoroughly,
dry
completely and replace. The unit has a low
voltage starter kit to help start under marginal
conditions. Do not rim under 103 volts.
Stainless steel sinks cannot be harmed by
boiling water. However, salt, mustard, mayon¬
naise and ketchup will cause pitting. Stubborn
stains will yield to paste made of water and
slightly abrasive cleaner. Be sure to work in
the direction of the polish-lines on the steel,
to keep the original finish. Fingerprints are
sometimes a problem. They can be minimized
Stainless Steel Sink
by applying a cleaner that leaves a film of thin
wax: simply wipe it on and remove the excess
with a dry cloth. After this, fingerprints can
be wiped off with a soft dry cloth, or one
moistened with a little wax cleaner. The
surface should always be washed before wax
is
applied.
Regular cleaning will prevent
build-up of scale and film. Ordinary soaps or
detergents are best for routine cleaning of the
stainless steel sinks. Rinse thoroughly with
warm water and wipe dry with a cloth to
avoid streaks and spots.
For further information on galley equipment
refer to page 39 for the refrigerator and page
42 for the range and oven.
To open the table, lift the table into a
horizontal position, depress latch and pull the
folding leg down until it locks in position. To
extend the table pull out on the latch
underneath the table right next to the leg and
lift the table and leg slightly off the floor.
34
Advertisement
Table of Contents
