Diamond
Series
ELECTRICAL CONNECTIONS
The pump comes complete with 10 mtrs of 3 core cable, however, should any additional
cable be required then the use of an approved waterproof cable connector is essential.
Ÿ
The power supply must be earthed and fused at 3amps.
Ÿ
Regularly inspect the cable for damage and deterioration
Ÿ
Always use a residual circuit device (RCD) for additional safety
Ÿ
For permanent installation to the mains supply, it is necessary to comply with the
regulations of the Local Electricity Authority.
Ÿ
Consult a qualified electrician if in doubt about any aspects of wiring.
SAFETY
Ÿ
Always
disconnect
SAFETY
installation/maintenance or handling of any kind.
Ÿ
The pump should never be run dry as this will cause the unit to overheat and damage it.
Ÿ
Do not attempt to modify this unit in any way and only use the recommended parts for
replacement.
Ÿ
Do not place in liquids other than water.
Ÿ
All connections must be Earthed.
Ÿ
Do not connect to any voltage other than that stated on the pump.
Ÿ
Do not use in water above 90°f / 30°C.
INSTALLATION
The pump should be sited on a firm base, raised from the bottom of the Feature.
Connect a suitable length of hose pipe if required. It is important to cut the multistage
hose connectors to the correct size to fit hose pipe.
Models
750
1100
1800
2500
Diamond Water Feature Pump
Diamond Water Feature Pump
Operating Instructions &
Operating Instructions &
Maintenance Manual
Maintenance Manual
the
mains
electricity
NEUTRAL = BLUE N
EARTH = GREEN & YELLOW
LIVE = BROWN L
supply
before
attempting
any