Advertisement
Initial Camera Settings
-
Insert fully charged battery and formatted SD card.
-
Set Date and Time.
-
Set Shooting Mode to "P" Program.
-
Set ISO to 100 and White Balance to auto "AWB."
-
Set the Drive Mode to "Single Shot."
-
Set Resolution to "L" and Compression to Superfine "S."
-
Set AF Frame to "Center" and AF Frame Size to "Normal."
-
Set Digital Zoom to "Off."
-
Set AF Point Zoom to "Off" and Servo AF to "Off."
-
Set AF-assist Beam to "Off."
-
In Flash Settings, set Red-Eye Corr. to "Off" and Red-Eye Lamp to "Off."
-
Set Light Metering to "Center Weighted."
-
Set Review to "5 Seconds" and Review Info to "Off."
-
Set Blink Detection and Grid Lines to "Off."
-
Set IS Mode to "Shoot Only" and Powered IS to "On."
-
Set Auto Power Down to "Off" and Display Off to "3 min."
-
Set Flash to "On
A strobe focusing light is recommended to assist AF underwater.
-
In Power Saving, set Auto Power Down to "Off."
-
In Power Saving, set Display Off to "3 min."
Note: Enable Macro
overexposure occurs, back away from the subject and zoom in and/or
use "-" Exposure Compensation.
External Accessory Lenses
Ikelite W-20 Wide-Angle Conversion Lens 6420
The front of the lens port accepts the 6420 W-20 and other 67mm
threaded wide angle or macro lenses without the need for an adapter.
Moderate vignetting will occur at widest angle camera lens setting with
these lenses. Zoom in to eliminate, or crop the image in post processing.
Bayonet mount lenses cannot be used with this housing.
flash always fires."
mode when shooting close-up subjects. If
3
Advertisement
