TDT RV2 Manual page 6

8-8
6. In the item list, select Internet Protocol (TCP/IP) or if there are multiples,
7. Click the Properties button.
8. Select Use the following IP address and enter these values:
9. Click OK. The RV2 can now be accessed by the PC.
10. Obtain the RV2 device address.
11. Enter the device address as shown in a windows address bar to access the
12. Access the files on the RV2 by reading or writing.
RV2 Video Processor
select Internet Protocol (TCP/IPv4).
IP address: 10.1.0.x, where x can be any value from 1 to 254 except 42.
Subnet mask: 255.255.255.0
Default gateway: Leave empty
a. Press the Live tab on the RV2 interface.
b. The device address is displayed at the top of the page to the right of
Device Name field.
RV2 file system.
Typically, the path \\RV2-XXXX\ is used to access the RV2 storage array,
where XXXX is the device serial number, but the name should be verified on
the Live tab.
WARNING! Do not attempt to write to the RV2 at any time while
data is actively recording Doing so may corrupt data currently being stored.
System 3