Features; Armrest; Casters And Pneumatic Tires - WOK BCW Customer's Manual

ARMREST

WARNING
To Mount:
1. Mount the armrest by sliding it into the frame as shown
(start the front of the armrest first).
2. You may need to compress the lock pin to allow the armrest
to completely slide into place. Make sure that the pin clicks
into places. The armrest design reinforces the back by
connecting the front of the seat frame and the back together.
To Remove:
Remove the armrest by compressing the lock pin and
Pulling up.
To Adjust Height:
Hold down lock pin located on the inner part of the armrest. Pull the armrest up to the desired
height, then release the pin back into the aligning hole of the armrest.

CASTERS AND PNEUMATIC TIRES

WARNING
Proper inflation extends the life of your tires and makes your wheelchair easier to operate.
1. Do not use this wheelchair if any of the tires are under or over inflated. Check weekly for
proper inflation level, as listed on the tire sidewall.
2. Low pressure in any of the tires may cause the chair to veer to one side and may result in
loss of control.
3. Over inflated tires may burst.
Never try to lift the wheelchair by its armrest. They may come loose
or break. If this occurs, the wheelchair may fall and cause severe
injury to you or others. Lift the wheelchair only by non-detachable
parts of the main frame. They are not designed to bear the weight of
the wheelchair.
If items, such as string or hair, become entangled between the caster
and the axle bolt the wheel chair may become hard to steer and roll.
Check monthly and clean if needed.
Lock Pin
11

FEATURES