Setting The Tad To Answer Calls; Using The Announce-Only Feature - Radio Shack TAD-798 Owner's Manual

43-798.fm Page 11 Monday, August 16, 1999 9:33 AM
If no outgoing message is recorded
when you press
OGM 1
TAD announces "You have no an-
nouncement one" (or "two") and sounds
four beeps.
SETTING THE TAD TO
ANSWER CALLS
To set the TAD to answer or not answer
calls, press
ANSWER
nounces "Answer on" (or "off") and
plays the outgoing message. If the AN-
SWER indicator is lit, the TAD is set to
answer calls.
Notes:
• You must record an outgoing mes-
sage before you can set the TAD to
answer calls.
• If you have set the TAD to not an-
swer calls, you can use a remote
phone to set it to answer calls (see
"Using Remote Commands" on
Page 17).
USING THE ANNOUNCE-
or , the
OGM 2
ONLY FEATURE
When the announce-only feature is on,
the TAD-798 plays OGM 2 but does not
let callers leave a message. (You must
have recorded an OGM 2 message be-
fore you can use this feature.)
To set the TAD to announce-only, be
sure the TAD is set to answer calls, then
. The TAD an- press
only," and plays the second outgoing
message. The number of recorded
messages and
To turn off the announce-only feature,
press
"Answer on," and plays OGM 1.
. The TAD says "Announce
OGM 2
appear alternately.
Ao
. The TAD beeps, says
OGM 1
11