Bastl Instruments bitRanger Manual page 10

LFO
BEND
RATE
HARD FREEZE
SYNC
B
LFO CV
+ –
CLK IN CONN 1
MUX1
DIVIDER BITS
A
B
ADVENTURE BITS
Patch any of the outputs
of the bitRanger to
a modular synthesizer
or anything else that
receives voltages... analog
keyboards, home made
synthesizers, arduinos etc.
MODULAR SYNTHESIZER
OUT FROM BIT R.
VCO HFO
BEND
BEND
VCO
Y T
SYNC
E
VCO CV HFO CV
2
o
XOR RESET
CONN 2
MUX2
DATA
MODE
CLK OUT
HFO
1 CLK OUT (clock out) jack
& switch
jack outputs a 5 volt square wave
   
1
controlled by the LFO. Use the CLK OUT
switch to determine if the output is the
CLK OUT O
LFO divided by 2 or divided by 32. The
CLK OUT OVERRIDE input socket can
be used to override the switch and send
alternate signals to the output.
2 CONN2
/BYTE CV OUT
jack, switch and socket
The CONN2/BYTE CV OUT switch sets
the functionality of the 3.5mm jack.
BYTE CV OUT mode = BYTE voltage
I
routed to jack.
Bits patched to the BYTE section will
II
be converted to stepped voltages which
can be used to modulate voltage
controlled parameters.
CONN 2 mode = jack is connected to the
zener diode protected CONN 2 socket.
In this mode the CONN 2 jack can
function as an input OR output.
Incoming signals above 5volts will clip
at 5volts. Below 0volts will clip at 0volts.
CONN 2 mode = jack is connected to the
zener diode protected CONN 2 socket.
CONN2 BYTE CV
2
1
/32 /2
OUT